Pusher Type Furnace

Pusher Type Furnace Specification

Usage
Industrial

Feature
Good Quality

Size
Standard Sizes

Condition
New

Type
Pusher Furnaces

Warranty
1 year

Pusher Type Furnace Trade Information

Minimum Order Quantity
1 Piece

Delivery Time
1 Week

About Pusher Type Furnace

Continuous Tray Pusher type Heat Treatment Furnaces up to a capacity of 10 MTPH to offer to the Automotive Castings, Forgings and other metal industries. These Heat Treatment Furnaces comprise of Tray Pusher type Hardening and Tempering Furnaces with Quenching facilities for polymer or oil as per the process requirement.The furnaces are fired with Wesmans or other make high efficiency burners supported by a full complement of combustion system consisting of combustion fan, atomizing fan, oil heating and pumping systems and/or gas trains. In addition auto ignition, flame failure safety and complete control systems are offered. Practically any type of liquid or gaseous fuel can be used viz. Furnace Oil, Light Diesel Oil, LPG and Natural Gas singly or a combination of any oil or gas in case of dual fired furnaces. Alsooffered with electrical heating through heat resistant Strip/Wire/Cartridge heating elements located along with the side/back walls/roof of the furnace. The heating elements of the furnace are suitably divided into number of heating zones with each zone of having their bank of heater. Each bank heater shall be connected either in STAR/DELTA or Parallel STAR/DELTA groups to have minimum number of heater per phase per group.The Hardening Furnaces are lined with high temperature grade ceramic fiber lining at the sidewalls and modules at the roof and door. The bottom hearth of the furnace is provided with combination of high alumina bricks backed by insulation bricks to minimize the skin temperature.he Tempering furnaces can be of Double Wall construction with inner SS 304 and outer MS or with Cera board with back up ceramic fiber lining at the sidewalls roof and door. The bottom hearth of the furnace will be provided with combination of medium grade alumna bricks backed by insulation bricks to minimize the skin temperature.The Tempering Furnaces can be directly heated through Burners located behind stainless steel baffles. To allow uniform heating inside the tempering furnace and ensure sufficient circulation of hot air, suitably sized recirculation fan assembly will be provided. Baffles fabricated from stainless steel sheets of AISI-304 are installed to guide the recirculation of hot gas inside the furnace. These baffles are suitably anchored with heat resistant studs from sidewalls and roof.

Tell us about your requirement